How to disassemble the sliding plate and inlet side ring of the extruder quick screen changer?
The extruder fast screen changer, also known as the single board dual station screen changer, removes the two ends of the sliding plate of the extruder fast screen changer (the method for square and circular single board screen changer is the same). The blue arrow in the figure indicates the removal of the screw (M20), and the sliding plate is pushed out by the oil cylinder (due to insufficient travel of the oil cylinder, a 450mm long round steel is required). After removing the sliding plate, the oil cylinder and the support rod of the oil cylinder are removed, and an open-ended wrench is used.
Extruder fast screen changer
Steps for disassembling the inlet side ring of the single plate screen changer:
After removing the sliding plate of the extruder quick screen changer, there will be a small gap between the inlet side ring and the main body. Use a copper rod to tap the gap up and down in turns until the ring is knocked out. Pay attention to evenly tapping the ring up and down. Attention: After removing the sliding plate and ring, it is necessary to clean the material on the sliding plate and ring!
hydraulic extrusion screen changer
Batte melt pump focuses on the research and development, production, and promotion of non-stop screen changer products, and supplies screen changer products in conjunction with multiple well-known domestic extruder equipment manufacturers. Relying on strong technological accumulation and invention patents, we have occupied a technological highland in the screen changer industry, providing melt filtration solutions to thousands of customers, improving efficiency and saving costs.
Email: info@battemachinery.com
Whatsapp: +86 158 38331071